We're in the ground!

On Wednesday May 18th we were able to get the rhizomes in the ground. A good rain fell Friday morning and Friday night that should set the scene for great growth. We hope to see some leaves breaking the soil soon.

An article in the local paper about the receiving of the  grant was published in the Denison Bulletin.

During planting John Klein formally of the M&M divide RC&D visited and wrote a new article about our endeavors and distributed that around. I hope to see more on that soon.

Planting got started early around 8:30 am on a great spring day. Rob sat with me on the back to plant rhizomes while Denny drove. We found the rate of rhizomes went fairly well. Rob and I fed about as fast as we could and Denny adjusted the speed of the tractor to adjust the rate per acre. Rob and I could see down the tube really well to make sure our approximate spacings were correct. The high rate plot was placed on 40" rows and 6" apart. This was altered from out original plan so that we would not plant double rows. The benefit of double rows did not seem worth it when we got into the field. if we find issues with the growth of 6" spacing we will make note and adjust next time.The mid population density was aimed to be 9" apart, but we also ran up to 12" a time or two while getting the speed right. The low population runs were 18" apart. The low population is more in the lines of large plantation style plant populations and seemed very straight forward if we were to do a much larger area.

Fist run of the season

final design planter in operation

Of the rhizomes, we received roughly 1,000 to a box. We were able to measure our work to how fast we went through boxes of rhizomes.  For the high density plot, each of the 4 500' runs took roughly 20 minutes and 2 full boxes to complete. The low population density plot took only 10 minutes and one box to complete. The middle range plot ran around 1.25 to 1.5 boxes each run.

The planter worked out really well. It dug a 4 inch furrow where the rhizomes were dropped into. then about 2" of dirt filled in on top of the rhizome followed by a packer wheel to increase the soil contact. When it was all done there were some good deep furrows in the field. It was visible that some rhizomes needed better cover. We expected to harrow the field. This was done and smoothed out the field. The rhizomes after the harrow work were about 4" deep in loose packed soil.

finished planting

This was about half done planting

Pulling the harrow through the furrows

After harrowing, the rhizome is just below my fingers. The soil level is at my thumb

There was a 20' stretch in one pass during the middle population where the plows came up too high and were not covering the rhizomes. It turned out to be a great example to view how the rhizomes were planted. After these pictures, we brought the planter back right beside the line and buried the rhizomes again.

Below is an older video I wanted to post of the planter in operation. This video was early on. One of the first field tests. After this video what was changed is mentioned in some posts below to optimize it for rhizomes, otherwise, very good operation.